View MasonrySaver items  
     
 
  • Item: MasonrySaver Epoxy Fortified Paver Sealer
 
  SKU: SS94001  Q/A: data-sheet
 
 
  Size: Available in 1 and 5 gallon recyclable containers.
 
 
  Property Type: Epoxy Fortified Acrylic
 
 
  Appearance: Milky White
 
 
  VOC Content: 220 g/L EPA Method 24  
     
  Case Pack: 1-gallon
Case Pack: 5-gallon
 
     
  Shelf Life: 24 months in original sealed container.  
     
  UPC Code: 7-09057-94001-6; 1-gallon
UPC Code: 7-09057-94005-4; 5-gallon
 
 
  Product Description  
     
 

MasonrySaver Epoxy Fortified Paver Sealer is a durable, waterbased, clear sealer designed to protect and beautify both clay brick and cement patio type paver stones. MasonrySaver Epoxy Fortified Paver Sealer is formulated utilizing an epoxy fortified acrylic resin that provides protection from both water and the ultra-violet light of the sun.

  • Freeze/thaw protection
  • Mildew/fungus protection
  • Protection from water damage
  • Protection from UV degradation
  • Protection from de-icing salts and chemicals
  • Provides a rich, wet look to stone & concrete
  • Suitable for areas subjected to hot tire exposure
 
 
  MasonrySaver Epoxy Fortified Paver Sealer
 
 
 

MasonrySaver Epoxy Fortified Paver SealerWhere to Use:
MasonrySaver Epoxy Fortified Paver Sealer can be used on most types of horizontal, above grade concrete applications including: clay brick, clay paver stones, cement paver stones and natural stone.

Application:
Apply two coats of material to the area to be treated, allowing the first coat to dry completely, approximately 2 hours, before applying the second coat. Avoid puddling and/or ponding of the product on the surface. Brush or roll product out until it is evenly disbursed and all puddles are removed. Less material will be required on the second coat than was required on the first coat.

Limitations:
Do not use over extremely dense or polished surfaces. It is not suitable for use over asphalt surfaces. This product is designed for horizontal surfaces only. Do not use on below grade applications that are subject to severe hydro-static pressures. MasonrySaver Epoxy Fortified Paver Sealer will not prevent water penetration through structural cracks, joints, or defects. The application of this product will reduce the vapor transmission rate of the substrate, which can result in a “blushing” effect to the surface during extremely moist conditions. Excessive moisture within the substrate can cause peeling.

What are the Coverage Rate(s):
Cement Pavers: 75-150 sq. feet per gallon.
Clay Pavers: 150-200 sq. feet per gallon.
Actual rates will vary based on substrate porosity.

When to Apply:
Application should only be made when surface temperature is between 50 - 90°F and is thoroughly dry. Do not proceed with application if temperature falls below 50°F or rainfall is predicted within 8 hours of application, or when surface is frozen.

How Long to Wait:
Minimum 2 hours; each coat.

Equipment:
Apply by airless or low pressure spray (20 psi), brush or roller. For airless sprayers, use tip sizes between .011 and .015. Two thin coats (2-3 mils DFT) as opposed to one heavy coat will provide the best results.

Safety Precautions to Observe:
Proper safety procedures should be followed at all times while handling the product. Wear chemical resistant gloves and chemical splash goggles. 

Refer to the Material Safety Data Sheet for important health and safety information before use.

 
  Worth Quoting...  
     
 

" Paver Sealer is formulated with special, heavy duty resins and mildewcides, that help to reduce the occurrence of fungus while also encapsulating the joint sand to retard the infiltration of ant colonies. It is also a paver sand sealer which helps keep patios cleaner by stabilizing the joint sand, bonding it firmly in place, and helping to keep the sand from washing out during periods of heavy rain. It also helps to reduce weeds from growing up through the joint sand. "

 
Copyright (c) 2002 - 2014 Small's Hardware Inc. All rights reserved. Privacy Notice | Contact Us
All trademarks and registered marks are the property of their respective owners.
DTEP is a registered trade name of Small's Hardware Inc. State of Ohio
Mailing Address • 109 S Wayne Ave • Lockland OH • 45215
Visit our StoreFront