to Use: MasonrySaver Masonry Cleaner/Degreaser®
cleans these surfaces: Loading Docks, Garage Floors, Driveways,
Parking Garages, Industrial Floors, Machine Shops Auto Repair Facilities
For general cleaning of dirt, grime, spots and stains, simply
spray MasonrySaver Masonry Cleaner/Degreaser on the area to be cleaned,
wait a minute or two and wipe off.
What about Concrete Oil Stains:
For oil staining on concrete floors and driveways, do not dilute
the product or pre-wet the surface. Apply MasonrySaver Masonry Cleaner/Degreaser'
full strength by pouring or spraying to the areas to be cleaned.
Work the cleaner into the stained area using a stiff broom or nylon
brush. Allow the product to work for approximately 20-30 minutes
before rinsing. Rinse with clean water. Rinsing with high pressure
water and with heated water will expedite cleaning. For severe stains,
multiple coats of cleaner may be needed.
Use 10 parts water to 1 part MasonrySaver
Masonry Cleaner/Degreaser to clean - Counter Tops, Painted
Walls, Bathrooms, Woodwork, Linoleum, Automobiles, Tile Floors,
Storm Doors, Boats, Garbage Cans.
Use at Full Strength on - Floor
Wax, Heel Marks, Smoke Film, Grease, Finger Prints, Ovens.
Do not use on composite floors, water-base painted surfaces
Safety Precautions to Observe:
Proper safety procedures should be followed at all times when handling
chemical products. Always wear chemical resistant gloves and chemical
Refer to the
Safety Data Sheet for specific safety information regarding