View MasonrySaver items  
     
 
  • Item: MasonrySaver Number 25 Floor Finish
 
  SKU: SS34012  Q/A: data-sheet
 
 
  Size: Available in 1 gallon recyclable container.
 
 
  Property Type: n/a
 
 
  Appearance: Milky White, Light Ammonia odor.
 
 
  VOC Content: n/a  
     
  Case Pack: 1-gallon; 6/case  
     
  Shelf Life: n/a  
     
  UPC Code: 7-09057-34012-0; 1-gallon
 
 
  Product Description  
     
 

MasonrySaver Number 25 Floor Finish is a highly durable water-based acrylic polymer interior floor finish. Formulated to be applied directly over MasonrySaver Decorative Concrete Sealer, Number 25 Floor Finish provides a rich, gloss finish, designed for high speed buffing, that resists dirt and floor scuffing and prolongs the floor life of Decorative Concrete Sealer

  • Provides a Rich Gloss finish designed for High Speed buffing.
  • Prolongs the floor life of MasonySaver Decorative Concrete Sealer.
 
 
  MasonrySaver Decorative Concrete Sealer
 
 
 

MasonrySaver Number 25 Floor FinishWhere to Use:
Apply directly over MasonrySaver® Decorative Concrete Sealer, Number 25 Floor Finish provides a rich, gloss finish that resists dirt and floor scuffing, and prolongs the floor life of Decorative Concrete Sealer. You can use this product with high-speed buffing.

Application:
for Previously Sealed Floors - Strip floors thoroughly to remove old wax and floor finish. Rinse floor thoroughly with clear water and allow to dry. If sealer coat has broken down to an uneven finish, reseal the floor using MasonrySaver Decorative Concrete Floor Finish prior to applying Number 25 Floor Finish.

for New Floors - New floors should first be properly cleaned, stained and sealed per manufacturer’s directions. When sealing, use MasonrySaver Decorative Concrete Sealer, or a comparable product. Allow sufficient time for sealer to properly cure prior to applying Number 25 Floor Finish.

What are the Coverage Rate(s):
1,500 - 2,000 sq. ft. per gallon per coat. Recommended application is to apply three coats of finish in traffic areas for every single coat of finish in non-traffic areas. A minimum of two coats of finish should be applied to all non-traffic areas.

When to Apply:
MasonrySaver Number 25 Floor Finish has been formulated for use on interior horizontal concrete surfaces. Surface and air temperature should be between 50°F and 90°F. Do not apply to surfaces that are damp or wet.

How Long to Wait:
Allow at least 24 hours to cure prior to buffing.

Safety Precautions to Observe:
Proper safety procedures should be followed at all times when handling chemical products. Always wear chemical resistant gloves and chemical splash goggles. 

Refer to the Material Safety Data Sheet for specific safety information regarding this product.

 
     
  Worth Quoting...  
     
  " A maintenance coat of #25 Floor Finish should be applied when the floor begins to exhibit an uneven sheen. For reapplications, three coats of finish should be applied to traffic areas and a single coat of finish should be applied in non-traffic areas. "  
Copyright (c) 2002 - 2014 Small's Hardware Inc. All rights reserved. Privacy Notice | Contact Us
All trademarks and registered marks are the property of their respective owners.
DTEP is a registered trade name of Small's Hardware Inc. State of Ohio
Mailing Address • 109 S Wayne Ave • Lockland OH • 45215
Visit our StoreFront