buy RemovALL 120 Safe Etch For Concrete

     
 

View all products by this Manufacturer

 
 
  • RemovALL 120 is no longer available in the US / Canada. see similiar
 
  Item: RemovALL 120 Safe Etch For Concrete
 
 
  Size: 5-gallon
 
 
  Appearance: Yellow Gel
 
 
  VOC Content: N/A  
     
  Case Pack: 5 gallon Pail
 
 
  UPC Code: 6-27951-12010-8  
  Quick Product Facts  
     
 

The RemovALL™ 120 Brush Grade products are water-based etching compounds specifically designed to provide a surface profile on green and mature concrete. Etching is often a prerequisite for application of a high performance paint/coating system:

  • Fast acting.
  • No muriatic acid.
  • Clings to vertical and horizontal surfaces.
  • Easy clean up with running water.
  • Non-ozone-depleting.
  • Water-based.
  • Biodegradable.
  • Non-flammable.
  • Contains no TAPs or HAPs.
  • Will remove most concrete sealers with extended exposure.
  • Low odor.
 
     
 

 

 
 
  RemovALL™ 120 Safe Etch™ For Concrete
 
 
 

buy RemovALL 120 Safe Etch For ConcreteTypical Uses:
RemovALL™ 120 Safe Etch™ For Concrete has been proven to effectively etch green and mature concrete and masonry. The depth of etching achieved with RemovALL™ 120 is the same as that of hydrochloric or muriatic acid.

The residue is easily removed by water rinsing. This product is suitable for treating vertical and horizontal surfaces.

Coverage:
Depending on the substrate, the coverage rate normally falls between 150 to 250 sq.ft. per US Gallon (14 to 23 sq.m./3.8L).

Optimum Temperature:
Ambient and surface temperatures should be in the range of 68 to 89°F (20 to 32°C).

The product performs effectively at lower temperatures - even at 32°F (0°C) but the dwell time increases.


Dwell Time:
The time required to etch the concrete depends on the type and age of the concrete. Most concrete will be etched within 15 to 30 minutes.

Rinse the product off as soon as an adequate etch has been achieved. If you want a deeper etch, apply fresh product and allow another 15 minutes of contact time. Repeat if additional etch is required.

Equipment & Tools:
This product is engineered for brush or roller application. Other equipment: brushes, rollers, scraper, masking tape, polyethene sheet, pressure washer, empty pails for clean-up, running water, rags.

Safety Precautions:
Proper safety procedures should be followed at all times while handling the product. Wear rubber gloves and safety goggles. 

Refer to the Material Safety Data Sheet for important health and safety information before use.

 
 

As with any etching compound, it is advisable to check the pH of the substrate before re-coating to ensure that it is compatible with the new coating system to be applied.

 
Copyright (c) 2002 - 2014 Small's Hardware Inc. All rights reserved. Privacy Notice | Contact Us
All trademarks and registered marks are the property of their respective owners.
DTEP is a registered trade name of Small's Hardware Inc. State of Ohio
Mailing Address • 109 S Wayne Ave • Lockland OH • 45215
Visit our StoreFront